Hold the Setup or Menu button and rotate the volume dial to adjust the time digits.

To set the clock on a Furrion radio, press and hold the Setup or Menu button until the time display begins to flash. Rotate the volume knob or use the tuning buttons to adjust the hour. Press the knob again to select minutes, adjust them, and press the button once more to confirm.

Step-by-Step Clock Adjustment

1. Activate the Unit: Press the power button to ensure the interface is active and the display is lit.
2. Access the Menu: Press and hold the Setup button for three seconds until the display enters the system configuration mode.
3. Navigate to Clock: Use the volume dial to scroll through the menu options until the word CLOCK appears on the screen. Press the dial to select it.
4. Change the Hour: Rotate the dial to set the correct hour. Pay close attention to the AM or PM indicators on the corner of the display.
5. Modify the Minutes: Press the volume dial once to toggle the selection from hours to minutes. Adjust the dial to the current time.
6. Save Changes: Press the Setup button one final time to store the settings and exit the menu.

Comparison of Configuration Methods

Most entertainment units allow for time adjustment through various inputs. The following table compares the typical duration and requirements for each method available on standard models.

Troubleshooting Common Time Issues

• Format Selection: You can switch between 12-hour and 24-hour modes in the TIME FORM section of the main setup menu.
• Memory Loss: The clock will reset to factory defaults if the main power supply or battery connection is interrupted.
• Input Timeout: If buttons are not pressed within ten seconds during setup, the system exits the menu automatically.
• Button Responsiveness: Ensure the faceplate is clean, as debris can prevent the Setup button from registering a long press.