A Chrysler 300 typically takes 5 to 6 quarts of oil, depending on the engine model.

The Chrysler 300 requires different oil capacities based on its engine configuration. The 3.6L V6 engine needs approximately 5 quarts of oil with a filter change, while the 5.7L V8 HEMI engine requires about 7 quarts. The 6.4L V8 SRT engine holds up to 7 quarts as well. Always refer to your owner's manual for the exact specification for your particular model year and engine type.

Oil Capacity by Engine Type

Engine Model Oil Capacity (quarts) Oil Type
3.6L V6 Pentastar 5 5W-20 Synthetic
5.7L V8 HEMI 7 5W-20 Synthetic
6.4L V8 SRT 7 0W-40 Synthetic

Steps to Check and Add Oil

  1. Warm up the engine for 2-3 minutes
  2. Turn off engine and wait 5 minutes
  3. Pull out the dipstick and wipe it clean
  4. Insert dipstick fully and remove again to check level
  5. Add oil in small amounts if needed, checking between additions

Common Oil Change Mistakes to Avoid

  • Overfilling the engine beyond the maximum mark
  • Using incorrect oil viscosity or type
  • Ignoring the oil change interval recommendations
  • Not replacing the oil filter during changes
  • Checking oil level immediately after turning off engine